Maintenance and maintenance of steel structure workshop
Industrial production plants are in full swing all over the country, and steel structure plants have beautiful appearance, diverse building shapes, bright colors, high factory production of steel components, low cost, short construction period, simple installation and construction, and flat layout. Flexible, steel has the advantages of light weight, convenient material design and calculation, and recyclability, etc., so that steel structures are widely used in modern industrial plants. At the same time, how to maintain the steel structure workshop in the later use is also very important. The following describes the maintenance and maintenance methods of the steel structure workshop in the later period of use. 1. Steel structure workshop maintenance: 1. The steel structure workshop is the entire connection of the structural parts. Electric lighting equipment and wires cannot be directly tied to the steel structure, and wire pipes or wire troughs are installed in isolation to avoid electric shock. 2. The steel structure components should be repainted and maintained after three years to extend the overall appearance of the steel structure workshop and prolong the service life. 3. After the steel structure workshop is completely installed, the owner shall not modify the structure without authorization, shall not remove any bolt members, and shall not add or reduce partition walls. 2. Maintenance of the steel structure workshop: 1. The steel structure workshop must be cleaned and maintained regularly. Generally, a routine inspection is carried out at least once a year to find potential problems. 2. If the metal plate surface of the steel structure workshop is damaged, it should be repaired in time to avoid the sun and rain. Corroded metal panels. If necessary, use all high-elastic nano-materials to protect the metal roof panel, and play an effective role in heat insulation and waterproofing, saving indoor air conditioning energy. 3. The cleaning of the exterior walls of the steel structure workshop depends largely on the environment. When cleaning the surface, be careful not to scratch the surface, avoid the use of bleaching ingredients and abrasive cleaning products, steel balls, and wear-resistant products. Rinse with clean water from top to bottom. 4. Branches, leaves and other similar objects should be cleaned up in time.